Cart masih kosong
Total: Rp0
Rp0
Berat : - gr
FC Specifications
Product Name: SpeedyBee F405 Mini 20x20 FC
MCU: STM32F405
IMU(Gyro): ICM42688P
USB Port: Type-C
Barometer: Built-in
OSD Chip: AT7456E chip
BLE Bluetooth: Supported
WIFI: Not supported
DJI Air Unit Connection Way: Direct soldering
DJI Air Unit Compatibility: Compatible with all DJI Air Units: DJI O3/RunCam Link/Caddx Vista/DJI Air Unit V1. Please use the solder pads < 9V> on the front right corner of the flight controller to make a pin-to-pin connection with the solder pads on the DJI Air Unit. UART1(T1, R1) is used for OSD and SUBS(R2) is used for DJI Air Unit’s internal SBUS receiver signal input.
Blackbox: 8MB Onboard Flash
Current Sensor Input: Supported. For SpeedyBee BLS 35A V2 ESC, please set Scale=250 and Offset=-500.
Power Input: 3-6S LiPo
5V Output: 4 groups of 5V output
9V Output: 1 group of 9V output
3.3V Output: Supported
4.5V Output: Supported
UART: 6 sets(UART1, UART2, UART3, UART4(Dedicated for Bluetooth connection)), UART5(Dedicated for ESC telemetry),UART6
ESC Telemetry: UART R5(UART5)
I2C: Supported
Supported Firmware: BetaFlight(Default), INAV
Firmware Target: SPEEDYBEEF405MINI
Mounting: 20 x 20mm 3.5mm hole diameter ，Compatible with M2 and M3 screws/Silicone grommets.
Dimension: 30(L) x 32(W) x 7.8(H)mm
Weight: 9.6g
ESC Specifications
Product Name: SpeedyBee 35A BLHeli_S Mini V2 4-in-1 ESC
Firmware: BLHeli_S J-H-40
Continuous Current: 35A * 4
Burst Current: 45A(5seconds)
ESC Protocol: DSHOT300/600
Power Input: 3-6S LiPo
ESC Telemetry: Not supported
Mounting: 20 x 20mm ∅3.5mm hole size，compatible with M2 and M3 screws/Silicone grommets.
Dimension: 35 * 35 * 5.5mm
Weight: 7.2g
